Monel K500 is a precipitation-hardenable nickel-copper amalgam that affiliations the awesome deteriorating square normal for Monel 400 with the additional bit of room of interminably basic quality and hardness. These refreshed properties, quality and hardness, are confirmed by adding aluminum and titanium to the nickel-copper base and by a warm overseeing used to affect precipitation, more often than not called age setting or making.
Totally when in the age-set condition, Monel K500 has a constantly irrefutable tendency toward stress-usage part in unequivocal conditions than Monel 400. Monel K500 has around different events the yield quality and twofold the adaptability when separated and Monel 400. In like manner, it may be other than strengthened by sullying working before precipitation setting. The likelihood of this nickel steel composite is kept up to 1200° F at any rate remains bendable and remarkable down to temperatures of 400° F. Its joining reach is 2400-2460° F.
This nickel composite is gleam safe and non-attracting - 200° F. In any case, it is conceivable to build up an overwhelming layer clearly of the material during supervising. Aluminum and copper might be unequivocally oxidized during warming, leaving an attracting nickel rich film on the outside. Pickling or wonderful dunking in hurting can clear this drawing in film and reestablish the non-dumbfounding properties.
The use limitation of Monel K500 is all around unclear from that of Monel 400 close to that when in the age-solidified condition, nickel amalgam K-500 has a clearly basic inclination toward stress-isolating part in express conditions. Monel K-500 has been acknowledged to be immune to a sharp gas condition. The blend of low use rates in expedient devour water and astonishing make compound K-500 especially reasonable for shafts of different partners in marine association. In stale or moderate moving ocean water, fouling may happen scanned for after by setting notwithstanding this setting backs off after a genuinely vivacious starting assault.
MONEL K500 COILS SPECIFICATIONS
Specifications: ASTM / ASME SB 127
Size:1000 mm x 2000 mm, 1220 mm x 2440 mm, 1500 mm x 3000 mm, 2000 mm x 2000 mm, 2000 mm x 4000 mm
Thickness:0.1mm to 12 mm Thk
Form: Coils, Foils, Rolls, Plain Sheet, Shim Sheet, Strip, Flats, Blank (Circle), Ring (Flange)
Finish: Hot rolled plate (HR), Cold rolled sheet (CR), 2B, 2D, BA NO(8), SATIN (Met with Plastic Coated)
Hardness: Soft, Hard, Half Hard, Quarter Hard, Spring Hard etc.
For more information
Contact Us: +91-9930388308
Email: [email protected]
Comments